Go Power! Smart Chargers were designed specifically to extend the life of deep-cycle battery banks. With a unique microprocess or controlled electronic design, Go Power! Smart Chargers offer multi-stage charging to accurately recharge and maintain battery banks without electrolyte loss.
Go Power! Smart Chargers are ideal for wet cell batteries. This GP Battery Charger series is a high frequency switching mode 3-stage battery charger and equipped with a micro controller and PFC circuit. This allows the GP Battery Charger to perform intelligent battery management and to provide highly reliable and power efficient operation.
The GPSC-12-10A features include an LED display of battery charging state short circuit and over-temperature protection and a battery type selector switch. The high efficiency electronic design makes them the ideal choice as either a back-up charger or for use with generators.
Charging Stages:
Bulk Stage: Constant current charging at a high voltage level at maximum amperage.
Absorption Stage: Tapering current for the last 10-20 percent of charge.
Float Stage: Lower voltage float mode to prevent electrolyte loss
Features:
Advanced 8-bit microprocessor control circuit reverse battery protected by fuse
Ignition protection
Output short circuit protection
Over power protection
Switch mode technology
Easy to read LED for system status
Compact size
Light weight
Power factor correction of 0.98 = efficient charge
Faster charging than conventional chargers
Three-stage charging: bulk, absorption and float modes
Full output over a range of input voltages (85-135 VAC), ideal for generator charging
Gel and lead-acid battery type selector switch
Multiple battery bank charging (fully isolated outputs)
